![]() You do not need to use/buy external debug probe. ![]() On-Board Debug Tools īoards listed below have on-board debug probe and ARE READY for debugging! Please click on compatible debug tool below for the further instructions. You will need to install debug tool drivers depending on your system. You can switch between debugging Tools & Debug Probes usingĭebug_tool option in “platformio.ini” (Project Configuration File). MCU RF board (MB1863): 2.4 GHz RF transceiver supporting Bluetooth ® specification v5.3. Information, please scroll table by horizontal. Ultra-low-power wireless STM32WBA52CG microcontroller based on the Arm ® Cortex ® M33 core, featuring 1 Mbyte of flash memory and 128 Kbytes of SRAM in a UFQFPN48 package. Supported debugging tools are listed in “Debug” column. platform = ststm32 framework = arduino board = cricket_l082cz build_flags = -D PIO_FRAMEWORK_ARDUINO_ENABLE_MASS_STORAGE Examples Įxamples are listed from ST STM32 development platform repository:ĭebugging - “1-click” solution for debugging with a zero configuration. PIO_FRAMEWORK_ARDUINO_USB_HIGHSPEED_FULLMODE PIO_FRAMEWORK_ARDUINO_ENABLE_CDC_WITHOUT_SERIAL ![]() PIO_FRAMEWORK_ARDUINO_SERIAL_WITHOUT_GENERIC PIO_FRAMEWORK_ARDUINO_NANOLIB_FLOAT_SCANF PIO_FRAMEWORK_ARDUINO_NANOLIB_FLOAT_PRINTF STM32Duino core has several options that can be configured using the nextĬonfiguration flags in build_flags section of “platformio.ini” (Project Configuration File): C/C++ standard library configuration platform = ststm32 framework = arduino board = hy_tinystm103tb board_re = maple STM32Duino configuration system To change the core you can use aīoard_re option that needs be added to build_flags:Īn example of “platformio.ini” (Project Configuration File) with maple core Some of the boards support all three cores. Official STM32Duino core is used (except cases when a board supports only one specificĬore). Therefore, have different functionality and set of internal libraries. All of them have been developed independently, There are three different Arduino cores for STM32 microcontrollers: STM32Duino,Īrduino STM32 (maple) and STM32L0. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. STM32Cube HAL and Nucleo-F401RE: debugging and unit testingĬonfiguration Switching between Arduino cores The ST-LINK is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. It offers a 32-bit product range that combines very high performance, real-time capabilities, digital signal processing, and low-power, low-voltage operation, while maintaining full integration and ease of development.įor more detailed information please visit vendor site. The STM32 family of 32-bit Flash MCUs based on the ARM Cortex-M processor is designed to offer new degrees of freedom to MCU users.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |